Detailed introduction

VENEER HOT PRESS DRYER MACHINE
The machine is a new type of veneer humidity dry hot press which is based on many years experience and development of our company. It has already been proved by many customers in forestry industry to be a most efficient and energy saving dry equipment. It suits the dehumidification and flatting of the core boards. The veneer is very flat after drying with sufficient shrinkage. The synchronized closing device with lever spring is installed symmetrically at the hot press, this device can make the hot pressed plates between each layer and the cores can touch or separate at same time. The specially produced hot pressed plates enjoys below features:fast dehumidification and fast steam removing. The frame structure is used for this device. The cylinder has upper oil inlet which can be installed very conveniently. The saturated steam is used as the heat
source to heat the hot pressed plates with high efficiency and low energy consumption. The automatic electric control system is used for the whole process of the dehumidification of the plates as per the set up programme. The operation is very simple. 
 
 Technical specifications:

ITEM NO.	DESCRIPTION	UNIT	SPECIFICATION
01	NOMINAL GROSS PRESSURE	(Tons)	40
02	NORMAL OLL PRESSURE	Mpa	12.7
03	DIMENSION OF HOT PLATENS	(mml×mmW×mmH)	2700×1370×42
04	DISTANCE BETWEEN HOT PLATENS	(mm)	60
05	NUMBERS OF HOT PLATENS	(p.c.)	13
06	NUMBERS OF DAYLIGHTS		12
07	CYLINDER	(mm)	4-φ100
08	STROKE OFCYLINDER	(mm)	720
09	POWER	(Kw)	11
10	OVERALL DIMENSIONS	(mml×mmW×mmH)	5220×1734×2998
11	NET WEIGHT	(Tons)	23